UK Plumber Forum 

A place of resource for Plumbers and Gas Engineers in the UK.

Ask your general plumbing questions here. Please have a quick check to make sure it wouldn't fit in any other category.
By PeterPendle
When we had an extension added to our house the builder installed an unvented water system using an Ariston hot water tank. Since it was my first experience of such a system it was some time before I realised the hot water pressure was very high when the tap was first turned on. On investigation, I then found the pressure in the expansion tank for the cylinder was very low. I pumped up to the recommended pressure and now experience water hammer (quite often but not always) when the tap is turned on. I suspect the builder also experienced this and eliminated the problem by reducing the expansion tank pressure. Can anyone advise the problem and solution?
lofty quienda

anarkali download mp3 storm slider download free p[…]

riche донецк

{кокосовое|масло riche https://biglioncoupons.[…]

Hello Peeps

Welcome to the forum Swifty!

Kitchen mixer tap

i want to know who taught him to tape the olive an[…]