UK Plumber Forum 

A place of resource for Plumbers and Gas Engineers in the UK.

Want to get squeaky clean but something's wrong? Go ahead and ask away in here.
By emmajackt
Hi, I have a Spa/Whirlpool bath and the on/off switch is letting water in from the top of the chrome switch. There is only a slight gap as can be seen in the first picture, but when showering, water gets into the switch and then comes out of the two small holes in the bottom of the switch, as can be seen in picture 2 and onto my bathroom floor. I cannot for the life of me think how to solve the problem. I thought of putting sealant into the two small holes and blocking them, but ii looks like they are there to prevent water getting into the air pipe, which attaches to the bottom. If anyone has any ideas, I would be most grateful. I have also attached a picture of the inside of the switch. Kind regards, Kev.
air button inside.jpg
air button inside.jpg (33.34 KiB) Viewed 2922 times
air button bottom.jpg
air button bottom.jpg (30 KiB) Viewed 2922 times
air button top.jpg
air button top.jpg (34.87 KiB) Viewed 2922 times
Hello Peeps

Welcome to the forum Swifty!

Kitchen mixer tap

i want to know who taught him to tape the olive an[…]

All members of the forum

Is there anyone who needs access to the profesiona[…]

Shower Brand identification

not actually after that valve, have another job bu[…]