No.1 U.K. Professional Trade Forum, Plumbing, Gas, Electric, Tiling and Joinery Forum

Hi, it's good to be here, just need some help and advice, i have put some pictures up, can you tell me if this will work? and be ok, or not ? i am going to add a 15 degree bend between the clay and what i have there already, then cut it all to fit in that gap, then i'm going to add a gulley..any help owul dbe helpful thanks

So you doing a full height stack?
You'll need a rest bend and some means of rodding as well.

SimonG wrote:So you doing a full height stack?
You'll need a rest bend and some means of rodding as well.

Hi SimonG, thanks for the reply, that made up piece there has a long radius rest bend on it, 87.5 and am not doing a full stack, the underground pipe part nearest the step, will be going to a stack, and somewhere on that stack there will be and air ventilation valve, you can use them at a lower height, far as i am aware, do you think what i have there, will be ok to use as i need ? and it not get blocked?, or can you offer any other solution, thanks

Ah right makes a bit more sense now. Was a bit hard to see from the angle of the pic.

Personally I would have an access chamber just in case.