UK Plumber Forum 

A place of resource for Plumbers and Gas Engineers in the UK.

Ask your general plumbing questions here. Please have a quick check to make sure it wouldn't fit in any other category.
By ricardo da Silva
#7043
My flat suffers from poor mains pressure and we have a direct heat setup with combi boiler.
The boiler is rated up to 3Bar, so I was thinking of installing a cold water tank to feed a twin pump supply cold and into the boiler for hot (both 15mm).

My questions are
Is this a feasible setup
Can I use a single 28mm feed from the tank to a double 15mm manifold into the pump or should I install two 22mm/15mm feed pipes from the tank instead.

Thank you in advance for any help you can offer.

what boiler is it? turn your boiler temp control[…]

Can't believe that someone suggested a compression[…]

Heating

as said, is the boiler downstairs? heat rises but[…]

Commercial project

Building regs part h gives the requirements for st[…]