UK Plumber Forum 

A place of resource for Plumbers and Gas Engineers in the UK.

Want to get squeaky clean but something's wrong? Go ahead and ask away in here.
By Webbix
#6223
Hi
am trying to replace a bath that is 1650x750 cannot find anyone that does one , reasonable priced at least. if i cant locate one i would have to get a 1600 x 750 but not sure how to infill the end where the gap would be

could anyone let me know , if you can get the size or if not, how to fill in the gap

thanks for you time in advance

Paul B
User avatar
By REDSAW
#6224
hi,
just use a peice of 3x2 batten then tile over.
you could also get a 1690mm and chop into the wall a bit.
diferent manufacturers have not all the same sizes, even a 1700 will vary 30mm from one to another and you will only be sure by physicaly measuring them.
i have even seen a bath with the end cut of and sat on a batten to fit¬ :o

Replacing leaking valve is preferred option but if[…]

Shower Pump

Volume of water out of pump can be no more than vo[…]

A coy way to ramp up the bill catching out those w[…]

Gravity or mains fed shower?

Thanks Redsaw but this is a pumped electric sh[…]