No.1 U.K. Professional Trade Forum, Plumbing, Gas, Electric, Tiling and Joinery Forum

Hi
am trying to replace a bath that is 1650x750 cannot find anyone that does one , reasonable priced at least. if i cant locate one i would have to get a 1600 x 750 but not sure how to infill the end where the gap would be

could anyone let me know , if you can get the size or if not, how to fill in the gap

thanks for you time in advance

Paul B

hi,
just use a peice of 3x2 batten then tile over.
you could also get a 1690mm and chop into the wall a bit.
diferent manufacturers have not all the same sizes, even a 1700 will vary 30mm from one to another and you will only be sure by physicaly measuring them.
i have even seen a bath with the end cut of and sat on a batten to fit¬